Apollo PCMCIA ISDN TA under WindowsNT4 . workstation By Euro-tech.co.uk

(BEFORE THE CARD IS INSERTED)

1 . Run setup from the CD (winnt\nt-ap\setup.exe)

2 . power down system, insert card, power on system.

RAS (remote access service) is fundamental to dialling in and out from NT.

Check if RAS is installed. This can be done by look ing at controlpanel>network>services

3a . If RAS is NOT installed.

- controlpanel>modems>add modem>select from list>have disk>point to driver location on CD (normally d:\winnt\drivers\) then click finish

- controlpanel>network>services>add>remote acess service, when prompted to select a device, select ISDNTA,>continue>restart.

- Controlpanel>network>adaptors>add NDIS adaptor from CD (d:\winnt\driver)>OK, click the properties of RAS, remove any devices listed, then ADD, select both ISDN TA1 And ISDNTA2>continue, NT should restart.

- MyComputer>Dialupnetworking(DUN)>make a new account and ensure that you select ISDN TA1 as the DEVICE.

- You will now be able to connect to the internet using the ISDN TA

3b . If RAS is already installed

- Controlpanel>network>adaptors>add NDIS adaptor from CD (d:\winnt\driver)>OK, click the properties of RAS, remove any devices listed, then ADD, select both ISDN TA1 And ISDNTA2>continue, NT should restart.

- MyComputer>Dialupnetworking(DUN)>make a new account and ensure that you select ISDN TA1 as the DEVICE.

- You will now be able to connect to the internet using the ISDN TA